References


 

References

 

Gordon, S 2005, ‘Structural Deformation Measurement Using Terrestrial Laser Scanners’, PhD thesis, University of New South Wales

Groom, R 2008, ‘Terrestrial Laser Scanning: getting close to lift off?’ Engineering Surveying Showcase, April, p. 12-15

Harvey, B R 1998, Practical Least Squares and Statistics for Surveyors, Monograph 13, The School of Geomatic Engineering, University of New South Wales, Sydney, NSW, Australia.

Jacobs, G 2007, ‘Leica Geosystems ScanStation 2 Boosts Scan Speed’, GeoConnexion, 23 July, accessed 21 May 2008, <http://www.geoconnexion.com/geo_news_article/Leica-Geosystems-ScanStation-2-Boosts-Scan-Speed/1869>

Leica Geosystems 2006, HDS Training Manual, Leica Geosystems HDS, Heerbrugg Switzerland

Leica Geosystems 2007, Leica ScanStation 2 Exceptional Speed, Outstanding Versatility, brochure, Leica Geosystems AG, Heerbrugg, Switzerland

Lichti, D, Stewart, M, Tsakiri, M, Snow, A 2008, ‘Benchmark Tests on a Three- dimensional Laser Scanning System’, School of Spatial Sciences, Curtin University of Technology

Leung, G 2003, ‘3 Dimensional Laser Scanners’, UG thesis, University of New South Wales

Linke, A 2005, ‘Calibration of Terrestrial Laser Scanners’, UG thesis, University of New South Wales

Loyola Spatial Systems, 2007, Leica Cyclone 5.8, media release, accessed 25 May 2008, <http://leica.loyola.com/products/hds/cyclone.html>

Pearce, L 2004, ‘Tunnel Surveys with “Cutting Edge” Technologies’, UG thesis, University of New South Wales

Raic, J 2002, ‘Terrestrial Laser Scanning’, UG thesis, University of New South Wales

Smith, P 2006, ‘Boat Hull Modelling using Terrestrial Laser Scanners’, UG thesis, University of New South Wales

Spitzer L 2007, ‘Spatial Solutions for Engineering Problems – Freeing the F-1 Rocket’, UG thesis, University of New South Wales

Waud, M 2003, ‘Terrestrial Laser Scanning’, UG thesis, University of New South Wales

Wyers, G 2001, ‘Laser Scanning Experiments’, UG thesis, University of New South Wales

 

 


 

Home   -   Abstract   -   Aim  -   Calibration   -   Testing   -   Conclusion   -   References